What's new
By:

MS9-29 missing chip?

cruzlink2 said:
Not hijacking the thread, just showing what became of the mess. Cleaned and scrapped off the corrosive and coated the exposed traces with solder.
Click to expand...

If you wish to cover the exposed traces again you can order UV curable solder mask fairly inexpensive like this

C$ 4.35 | Mechanic UV Curing Solder Mask Ink, 10ml, Green, Red, 6 Color, PCB, BGA Circuit Board, Insulating Protect, Soldering Paste, Flux Oil
https://a.aliexpress.com/_mKq1QxC
 
brad808 said:
If you wish to cover the exposed traces again you can order UV curable solder mask fairly inexpensive like this

C$ 4.35 | Mechanic UV Curing Solder Mask Ink, 10ml, Green, Red, 6 Color, PCB, BGA Circuit Board, Insulating Protect, Soldering Paste, Flux Oil
https://a.aliexpress.com/_mKq1QxC
Click to expand...
My apologies for my ignorance.
Could you still apply that on board to prevent that from happening? A preventative? Is that what it is basically?
 
cruzlink2 said:
It was the old caps that leaked and caused the corrosion on the solder mask and traces.
Click to expand...
Wow.. it cause that much damage?? Good thing I did a capkit on imine Even though at a risk of blowing it up. Unfortunately I won't know until I solder that damn smd resistor tomorrow and that hack Job I did with that wire being spliced in like that.

I'll let you guys know tomorrow.

Also, would like to thank all of you here for all your help, I am very grateful .
 
erdrick1980 said:
Wow.. it cause that much damage?? Good thing I did a capkit on imine Even though at a risk of blowing it up. Unfortunately I won't know until I solder that damn smd resistor tomorrow and that hack Job I did with that wire being spliced in like that.

I'll let you guys know tomorrow.

Also, would like to thank all of you here for all your help, I am very grateful .
Click to expand...
You're welcome, yea once them caps leak imagine years of that fluid sitting there and the the higher temps don't help once the fluid leaked.
 
Update:

Got the smd resistor today and put everything back together and started right up no issues.
I want to thank all of you here that helped me out. If it wasn't for you this would not had happened. Also, the sharpness mod is awesome!!
 
Some pics. 20221214_071027.jpg20221214_070935.jpg20221214_071029.jpg
 
You must log in or register to reply here.
Back
Top