Hatsune Mike
Champion
Just paid the tariffs, ouch. Hope to have the boards today or Monday.
I would hope so.people well get a pm if they come up on list?
You don't want splitfire for this. Splitfire is for splitting out video to non-arcade monitors. Jamma video is high impedance unlike consumer tvs/scart which is low impedance.Hi, im not sure if this is what I need for what I want to do. Hoping someone can help?
I want to split my image over two 15khz cabs (they both have a 1-player cp). I already have both controls wired into a single jamma edge. So I just need the video and audio split to the 2nd cab.
I was thinking splitfire is what I want. So had 3 quick questions.
A) is there any noticeable lag on the 2 images and are they in sync (timing wise)?
B) the 2nd cab is not wired for jamma, but the monitor (that I want to link to) is currently connected by a vga cable to a 15khz signal (from a pc setup with arcadeVga card). Will this be a simple plug and play solution into the splitfire vga connection?
C) is there 100% pass through of all the other jamma pins (I have a pi2jamma setup that uses every single pin except the 7th)
Sorry for all the questions. Hope it's straight forward. Appreciate all the effort.
Sorry to hear about your OSSCWherever I am on the list, there is money waiting.
I lost my OSSC during the move, and this thing is exactly what I need to direct feed into my Datapath card.