Namco System 11 - Dancing eyes - not able to get into test mode

[mawrick]

Have a Namco System 11 - Dancing eyes (that came with a cab I bough) and thought I'd try to get it up and running, the game seem to run, at least the attract mode, but the screen colors are way of, from what I'v seen online it's possible to adjust colors on these systems from the test menu ?

However if I put the Dip 1 to on and reboot it won't go into test mode, when measuring the switch it does seem to work.

Any tips on what might cause this, and also if there is any other ways to get into test mode when using a HAS Supergun ?

 

[pierpa86]

Check one this two pins R or 15
In some game you have to keep it press.

 

[nnap]

This, many Namco games require you to keep the test button pressed.

 

[mawrick]

Check one this two pins R or 15
In some game you have to keep it press.

ok, seem there is no connection between R and gnd, or 15 and gnd, with the switch in different position, would guess I would need to jump between those (I tried holding in the switches on the has, but not sure if that would register on this setup).


thanks

 

[pierpa86]

ok, seem there is no connection between R and gnd, or 15 and gnd, with the switch in different position, would guess I would need to jump between those (I tried holding in the switches on the has, but not sure if that would register on this setup)

Yes take one of that two pin and put on gnd, if not work try the other, it should be pin15

 

[AeroCity20XX]

I'd have to check my Dancing Eyes board but I don't think you can adjust colors from the menu.

I do know it just goes into test mode as soon as the test button on my cabinet is pressed.

 

[HDemon]

Have a Namco System 11 - Dancing eyes (that came with a cab I bough) and thought I'd try to get it up and running, the game seem to run, at least the attract mode, but the screen colors are way of, from what I'v seen online it's possible to adjust colors on these systems from the test menu ?

However if I put the Dip 1 to on and reboot it won't go into test mode, when measuring the switch it does seem to work.

Any tips on what might cause this, and also if there is any other ways to get into test mode when using a HAS Supergun ?

To get into test mode without holding test switch in the cabinet/supergun you need to flip a little switch on the PCB

You can adjust brightness with the pot on the top GPU/CPU PCB.

See picture attached.

 

[mawrick]

Haven't checked by briding yet, but the dip switches has been tried and it does not boot into service menu as I expected, so might be something wrong there also (though the switch itself do work it seem).

Not 100% sure (as I'v never seen this game in person), but just thought the colors seem very "vacky" so doubt they where supposed to be ike this ?..

Reason I thought the board had an adjustment for colors was this video:

from a tekken which seem to be a system 11 board....

 

[pierpa86]

Tekken is a sys12 DancingEye system 11 take a picture of the caps on gpu board, you may need to replace just caps

 

[mawrick]

Tekken is a sys12 DancingEye system 11 take a picture of the caps on gpu board, you may need to replace just caps

added