What’s the depth (from the frame to the back) of that K7000?
This might have gotten lost with all the flaming in the last posts... but since now we seem to be back on track.... someone has an answer to this? (I mean the standard factory K7000)
I got them. But as far as CRT's goes, the repro is designed for the WG 19" K7000 and only the WG 19" K7000. No point posting tube measurements.
These are my 4 leads.
Please help
On the top, one pin is neutral. The other 4 hots for 100/110/120/130 VAC for use with a wide array of monitors. The important thing for the K7000 is that it is ran off an ISO. I don't know off the top of my head is proper VAC for the K7000, but check the manual. Then use a meter to find the proper VAC. Sometimes volages are stamped on the frame of the ISO and you might miss it at first glance.
I've litterally seen K7000's ran at each one of the 4 voltages listed above, which is probably why the chassis dies so often (operator's specials!).
Can someone please confirm the the pin count on the K7000 tube to see if were dealing with 2 different neckboards?
8-pin
I may need to sweet talk the dump guy again..
I wouldn't bother. The repro is designed to work with the WG 19" K7000 and only the WG 19" K7000. Checking the dump implies you are going to tube swap. The repro is designed to work with the WG 19" K7000 and only the WG 19" K7000.
just chiming in with some positive vibes to say that despite technical difficulties this project looks awesome.
I'm based in europe and would have to buy one with monitor since I'm not experienced enough to deal with this kind of hardware.
I don't own a cab because I can't deal with the high maintenance but I can see this being a great way to get started.
Ufortunately the cabs are BYOM at the moment.A new or used monitor option would be awesome.
Hopefully we can do some prelim tube swap work to the point we have a solid plan of attack.
How is 19” k7000 stock in Spain?
It’s pretty low and burned here in the US.
Chassis are plentiful however. And you don't need the frame because the repro will have a K7000 compatible frame for use specifically with the repro. So now you just need a compatible yoke. Specs of which you can find
here.
Don't bother with tube swapping, it is going to be a dice roll. The repro is designed for the WG 19" K7000 and only the WG 19" K7000.
Forget about k7000 in Europe.. You are going to get more lucky with Hantarex or Intervideo.
Forget about the Hantarex or Intervideo. The repro is designed for the WG 19" K7000 and only the WG 19" K7000.
20" MTC-9000 is the one you want to get in Europe. Same mounting points as the K7000.
Excellent chassis. Once you replace the flyback it's super reliable. Replacement tubes are very common too.
Forget about the 20" MTC-9000 too. The repro is designed for the WG 19" K7000 and only the WG 19" K7000.
Anyone see a repeating theme here?