WTB Sega OutRunners Parts

[GalileoFigaro]

Hello

I´m looking for this parts for muy outrunners

- Filter wiring harness (all with red arrows)
- Radio Panel LCD with harness x 2 Units
- Radio I/O PCB 839-0583 x 2 Units
- DJ - Music - Select Buttons x 2 Sets (6 buttons)

Thank You

 

[makedome]

hello, did you find the parts you were searching for? Meanwhile can you please tell me how and where are the 2 green buttons on the radio console connected? I would really appreciate it.
Thanks

 

[Gamesmonkey]

I will check my radio buttons later, but I don't think the green button is connected to anything.
I think it is only used if you don't have the red key ignition/sart.?

Cheers Justin

 

[makedome]

hello Justin and thanks for your feedback. I found that there are 2 versions of the radio console one with and one without the green button.
The green button should serve to transfer the coin to the related player, just if you have a single coin door. I found also on the manual the wiring. Just I'm not sure if on my cabinet there are unconnected wires or there are none. Anyway please if you can check i would be more sure. Thanks again

 

[Gamesmonkey]

My radio came out of a twin Outrunners
, the wiring has no connections for the green button.

 

[makedome]

Hello, thanks for checking. On my side I'll try to connect it following the schematics

 

[hursit]

is there anyone help me about this Outrunners Setup ?
thanks.

 

[makedome]

if I can, I'll do. What you need to do?

 

[hursit]

if I can, I'll do. What you need to do?

is it possible to connect a PC wheel to this original Arcade PCB ?
what do you think about it ?

thanks.

 

[makedome]

why would you do that? you don't have the original arcade cabinet? the potentiometers connected to the steering wheel and brake and accelerator are linear 5k ohm so you should check what is inside your pc wheel and if there is some electronic circuit in between. In case adapt the connectors.

 

[Casselfornia]

Yaton has one of the radio panels available.

Meanwhile I am in a bit of struggle connecting the radio unit to my PCB without the 839-0583. Can someone tell me which pins connect to the 14 pin LCD connector and in which order? From the filter board.