Hi,
I bought a Darksoft Multi CPS2 kit last week and installed it on the day of arrival. It works just fine with unencripted roms but not the encripted set.
The donor board is a Marvel vs Capcom. This is actually a revision 4 board that was factory converted by Capcom. It has a GPal and a jumper wire on the reverve of the board. I have left the jumper wire in place. It was fully functional with battery. Battery removed
I have set all the jumpers as per the instalation guide
The 2 Darksoft boards are correctly installed and seated and the sd card works (evidenced by the unencripted roms working fine)
I downloaded the encripted and unencripted roms from the same advertised source
The key writing wires are installes correctly and I have done a continuity test on each wire right from the wire attached to the darksoft board all the way to the point on the a board (also checked from pad to spot on b board)
I changed wire type to kynar wire incase the first wire I used had too much resistance
I have shorted EXC5 at least 5 times for up to 1 minute.
When I use encripted roms, the game starts to boot then either shows zeros and 1s on screen (1944) or flickers a bit then goes black(mighty pang)
The LCD always shows a success whether using encripted or unencripted roms.
I have ran the 2 test programs from the SD card and both completed fine.
It may be in my head but I have noticed unencripted games take longer to flash than encripted ones.
I will attach photos but at this point have tried everything I can think of or have read about.
Thanks
I bought a Darksoft Multi CPS2 kit last week and installed it on the day of arrival. It works just fine with unencripted roms but not the encripted set.
The donor board is a Marvel vs Capcom. This is actually a revision 4 board that was factory converted by Capcom. It has a GPal and a jumper wire on the reverve of the board. I have left the jumper wire in place. It was fully functional with battery. Battery removed
I have set all the jumpers as per the instalation guide
The 2 Darksoft boards are correctly installed and seated and the sd card works (evidenced by the unencripted roms working fine)
I downloaded the encripted and unencripted roms from the same advertised source
The key writing wires are installes correctly and I have done a continuity test on each wire right from the wire attached to the darksoft board all the way to the point on the a board (also checked from pad to spot on b board)
I changed wire type to kynar wire incase the first wire I used had too much resistance
I have shorted EXC5 at least 5 times for up to 1 minute.
When I use encripted roms, the game starts to boot then either shows zeros and 1s on screen (1944) or flickers a bit then goes black(mighty pang)
The LCD always shows a success whether using encripted or unencripted roms.
I have ran the 2 test programs from the SD card and both completed fine.
It may be in my head but I have noticed unencripted games take longer to flash than encripted ones.
I will attach photos but at this point have tried everything I can think of or have read about.
Thanks
Attachments
Last edited: