saucydaddy
Student
Hey guys, so I recently picked up a taito type x from someone here. Unfortunately the CPU pins were bent so I had to realign them with a credit card but I think it's working now (never done that before lol). The issue is I'm not sure how to fully verify that this is working properly. It now boots up and stays booted up but now I get to the JVS I/O error which I'm assuming is because I don't have a proper input connected?
I watched this video
View: https://www.youtube.com/watch?v=vSkUwBJf_E4
and picked up a Tuscon Logic board since it seemed the best way to test this quickly and cheaply.
https://tucsonlogic.com/
I tried connecting the logic board to a micro-usb power supply that's plugged into the wall and the data usb connected to the TTX. I didn't have any pins wired up but was hoping that wasn't necessary to get it to work. Does anyone know if this would work or another solution/product to quickly test that the system actually works? I don't have a proper cab to test this with (it's on the way) but I have buttons and wires.
Let me know if you need more information or anything, thanks
I watched this video
and picked up a Tuscon Logic board since it seemed the best way to test this quickly and cheaply.
https://tucsonlogic.com/
I tried connecting the logic board to a micro-usb power supply that's plugged into the wall and the data usb connected to the TTX. I didn't have any pins wired up but was hoping that wasn't necessary to get it to work. Does anyone know if this would work or another solution/product to quickly test that the system actually works? I don't have a proper cab to test this with (it's on the way) but I have buttons and wires.
Let me know if you need more information or anything, thanks