I have a few arcade monitors that I would like to test.
Mostly my 19" k-7000 and 19" VGA to get ready for some cutes that are going to headed my way, along with a bunch of tube swaps.
I have been remounting my monitors to test inside the cabs which feels dangerous and painful.
I would like to create a "monitor testing station" That I can plug my monitor into outside of the cabs and run tests easily.
I would like to get recommendations for a setup like this.
I believe I will need a PSU, JAMMA loom, Isolation Transformer and controller input solution as well as RGBS connector adaptors. an all in one purchase solution would be ideal too.
I want to sink my teeth into these monitors SOOO BAD.
I've seen a lot of pcb test stations but very few monitor test stations. Any guidance on recommended hardware would be awesome.
Mostly my 19" k-7000 and 19" VGA to get ready for some cutes that are going to headed my way, along with a bunch of tube swaps.
I have been remounting my monitors to test inside the cabs which feels dangerous and painful.
I would like to create a "monitor testing station" That I can plug my monitor into outside of the cabs and run tests easily.
I would like to get recommendations for a setup like this.
I believe I will need a PSU, JAMMA loom, Isolation Transformer and controller input solution as well as RGBS connector adaptors. an all in one purchase solution would be ideal too.
I want to sink my teeth into these monitors SOOO BAD.
I've seen a lot of pcb test stations but very few monitor test stations. Any guidance on recommended hardware would be awesome.