Hello all, I have a minor issue with VC3 monitor.
During calibration, I do my best to aim and shoot at the calibration points. I have gone through calibration countless times, but always the same exact issue.
Once I activate the cursor to track the gun position on the screen. I can sweep anywhere on the screen and it has very good tracking, until I get to the left side. If I start at the center point and move perfectly horizontally left, the cursor curves and bends down below the left calibration point. It's the only part of the screen that does that. It's not a huge amount, but the tracking cursor definitely ends up below the point by an inch or more.
I don't have a ton of controls for the monitor itself, just those 4 white knobs in the back that doesn't appear to address any sort of curve... and what I know about messing with the monitor itself is to basically not to, unless I want some serious shock/death.
Is there anything that can be done about the tracking curving like that? I've checked/cleaned every sensor, and checked the mirror in the cabinet, all seems good.
Thank you!
EDIT: Whoops! Just saw there is a dedicated monitor section, sorry!
During calibration, I do my best to aim and shoot at the calibration points. I have gone through calibration countless times, but always the same exact issue.
Once I activate the cursor to track the gun position on the screen. I can sweep anywhere on the screen and it has very good tracking, until I get to the left side. If I start at the center point and move perfectly horizontally left, the cursor curves and bends down below the left calibration point. It's the only part of the screen that does that. It's not a huge amount, but the tracking cursor definitely ends up below the point by an inch or more.
I don't have a ton of controls for the monitor itself, just those 4 white knobs in the back that doesn't appear to address any sort of curve... and what I know about messing with the monitor itself is to basically not to, unless I want some serious shock/death.
Is there anything that can be done about the tracking curving like that? I've checked/cleaned every sensor, and checked the mirror in the cabinet, all seems good.
Thank you!
EDIT: Whoops! Just saw there is a dedicated monitor section, sorry!
Last edited: