Recent content by Esom

I am not familiar with the MiSTer video outputs, but no one else seems to have lent some info. When using the D9800 with a signal in any other form than 15/25/31kHz, it has a fit. If the MiSTer is outputting something else to begin with (as is frequently an issue with Batocera based PC setups)...

Picked up a Makvision M2929D7-SS, but it has no remote board. I found no schematics online, and only one photo of the remote board itself. Anyone have this monitor/board that could post some photos? I mostly need to see if there are any other components on the board besides the buttons. Or, if...

Fantastic! This will make a lot of very happy campers! It might be the only reference available right now.

Three screws on the front t face, remove those and the top slides forward and up to dislodge it.

Siiiiiick! I would also echo the previous post, dispite having a dedicated T5 cabinet. Any misalignment and its gonna look hokey.

Bit of a necro, but: Had to get a couple 29s out of my Vs. cab alone. Ratchet straps plus ceiling beams = floaty big bois!

Looking for a replacement flyback for my Nanao MS-2930-SE. Model Number is MSU1FUS11 / HR 48367

I have a Nanao MS-2930-SE wirh a Toshiba tube from a New Versus City cabinet. Something is causing an intermittent overvoltage and it appears to shutdown just after energized... sometimes. Sometimes it starts right up and works happily for hours. I have read that these monitors can crack their...

I have made a booboo. I have damaged my IO board by plugging in the power connector incorrectly. I need to replace all the diodes and caps just above the power input header, but several of them got burned up and I can't read the markings. Anyone have a schematic, or values for D1/2 C1/2/3/4? Thanks!

So, I got a Tekken 2, and it kinda sorta worked except one of the pins on this l'il guy (attached photo)was snapped off. I tried to desolder the pins and install another... but about half the pads came off with the pins. 😞 So, I need another. The daughter board or a whole PCB, either is fine...

Duh, someone else figured it out for me... the TPG was at fault 😆

I received this monitor non-working. I finally got it to produce an image, but the image is all wonky. It looks like the whole image is shifted left 50%. Left is on the right, right is on the left, and a black space in the middle. It's not scrolling, it's all locked in place. Fiddling with the...

Sold at asking price.

Soul Calibur - $150 Freshly serviced, plays well, sounds great!

Thank you so much! Another user has come to my rescue, so I think I'm set now. Thanks all!