Capcom "Forgotten Worlds' Spinner Repro by Hursit Official Interest Check Poll

How many would you preorder/buy?

  • 1

    Votes: 33 23.7%
  • 2

    Votes: 88 63.3%
  • 3

    Votes: 5 3.6%
  • 4

    Votes: 12 8.6%
  • 5+

    Votes: 1 0.7%

  • Total voters
    139
I went down the homemade route, and "lightly modified" a few Sanwa 30mm buttons :whoopsie: They're now on my W2 cab, so I went for the Blue/Red combo.

They don't have the same diameter, but adding a rubber black ring around them made them fit snugly and look rather nice (imo)

They could be shaved down a bit more, but I quite like them raised. They are push button spinners after all. And I haven't had to tack/glue them in, even with a youngster giving them a good bashing they've stayed in place!

Screenshot 2026-11-18 165420.png Screenshot 2026-11-18 165407.pngScreenshot 2026-11-18 165436.png
 
Last edited:
And just in case you're thinking of doing it with the new Kraken spinners, they fit nicely too. I just needed to use a slightly thicker ring. That being said, some of the older buttons I tried seemed slightly smaller. Fractions of a millimeter make all the difference!

Getting a pack of different sized rings is definitely recommended.

Screenshot 2026-11-18 194850.png
 
Thank you so much for the additional detail. I noticed your panel has the Japanese text on it (yellow ribbon under spinner). Never seen that design offered before.
 
Back
Top