Jasen's Customs: CPS2 Case Thread

[RepairGuy95]

Same as above.

 

[JasenHicks]

This is for the newer versions of the case with the m3 screws on the bottom.

 

[ZweiGP01]

Much appreciated, also, thanks for the refund on the CPS3 discs.

 

[JasenHicks]

If you have an older case with the #6-32 stand offs, a cylinder with outside dimensions of 10mm with a hole in the middle of 6mm is fine. 9.85mm tall should do it.

 

[JasenHicks]

If you have been wanting a CPS1, CPS2, or CPS3 case I have news. I am willing to do a FINAL RUN of 25 of each case, minimum to make it happen, but the costs are a lot more expensive thanks to current world events. Here's the pricing:

1. CPS3 - $269.95
2. CPS2 - $429.95
3. CPS1 - $539.95

If this is too expensive, I get it. I just can't make them cheaper anymore due to raw material and labor costs. Let me know your thoughts on this - I won't risk the run if the new pricing is too expensive; I can't take the financial risks given the low margins for all of our products and the plan to cease direct to consumer sales in August.

 

[JasenHicks]

Unfortunately, the CPSx final run didn't meet the minimums to get across the finish line. I understand why - the new prices caused by a multitude of factors impacted it for sure. We tried to muscle through and it wasn't enough. All orders have been cancelled and refunded.