What's new
By:

Milspex's custom arcade instruction strips

tumblr_o7u1r1trsC1sns8t5o1_1280.png


Work in progress....
 
Are there any changes from the original? Or compared to the one I cleaned up?
 
Man, that looks pretty darn good. Question, are the inks used by the printer UV stable/resistant? Meaning they wont fade over time?! Or will I have to use a UV protection coating?
 
Milspex said:
A little iffy about the logo placement, and probably needs some more graphics to go along with the logo.
Click to expand...
I guess this is a bit of a naughty suggestion, but if you'd rotate the the logo slightly counter clockwise, it might go better with the horizontal layout of the strip? Centering it on the strip could also work.
 
Please do, I think centering the logo will balance it out, looks great.
 
I tried that at first but rebuilding the whole thing made it a lot cleaner and easier. Top is my rebuild, bottom is from a scan from your website. Nonetheless I use a whole lot of stuff from your website and it is all very good stuff, but the dodonpachi logo was a nightmare.

tumblr_o8def05rOu1sns8t5o1_1280.png
 
Milspex said:
I tried that at first but rebuilding the whole thing made it a lot cleaner and easier. Top is my rebuild, bottom is from a scan from your website. Nonetheless I use a whole lot of stuff from your website and it is all very good stuff, but the dodonpachi logo was a nightmare.
Click to expand...
I see your point :) Maybe I should update some of the original scans with fresh ones one day. Glad you like the site!
 
You must log in or register to reply here.
Back
Top