Already packed, will go out tomorrow. Thank you!Awesome. Saw the email notifications and ordered two of the boards I'd been looking to get. Thanks, Everten.
Already packed, will go out tomorrow. Thank you!Awesome. Saw the email notifications and ordered two of the boards I'd been looking to get. Thanks, Everten.
Awesome! Just ordered an STV B thank you!Adding stock shortly. Please be aware you may need to sign up for stock notifications again if you miss this round.
Also worth noting, all "G-NET / ZN-2" boards will ship in the new format that is compatible with ZN-1 boards.
https://www.tindie.com/stores/everten
Yes, there are locking tab connectors holding it down. Start with one connector and slowly loosen the locking tab, once you get one raise up a bit it should start to get easier.So how do you remove the daughterboard on the ST-V? I removed the two screws+nuts but is still in there real good. Are there tab locks on the pins? I see these see through white plastic on mine.
Bah, have the G-Net boards sold out already? I've grabbed a Namco board anyway.
Are there any more of the spinner-enabled F3 boards due?
Please send me PMSo there is no more ST-V kick harness version B?
I added it to my cart on tindie but it didnt seem to order it when I checked later
I NEED that bro!I've been working on the MV1FZ a bit (@ark125 got me thinking about it again). Ready to have a few people test it out again.
![]()
You're damn right. Pending a few parts, but you are on my list of people getting a test board. I'll shoot you a PM soon.I NEED that bro!
https://d3s5r33r268y59.cloudfront.n...verten_Neo_Geo_MV1FZ_Stereo_PCB_Datasheet.pdfCan you talk about installing the mod?
Obviously its a solder install, but specifically are we to remove the surface resistors (disabling JAMMA output/onboard amp) before soldering this PCB in place (that was recommended in the past/by Jamma Nation X).
@ark125 beat me to it. All of my boards have 'datasheets' on Tindie that include instructions.Can you talk about installing the mod?
Obviously its a solder install, but specifically are we to remove the surface resistors (disabling JAMMA output/onboard amp) before soldering this PCB in place (that was recommended in the past/by Jamma Nation X).