freddiefiasco
Professional
Thanks all. I was able to figure it out by posting my question on here. I ended up re-wiring my harness and there was a cross connection between my 1P SW1 and 1P SW3. After testing continuity, these two switches ended up being connected.
My Multi 1.4 works again.
However, I did find that when I loaded 2.0, none of the controls registered. Not sure what I'm missing but if my harness and JVS works with 1.4, were mappings changed in 2.0? The changelog did not mention map changes that I am aware of.
My Multi 1.4 works again.
However, I did find that when I loaded 2.0, none of the controls registered. Not sure what I'm missing but if my harness and JVS works with 1.4, were mappings changed in 2.0? The changelog did not mention map changes that I am aware of.