BilonFullHDemon
Professional
Home Arcade System
- Thread starter RGB
- Start date
After a long break, I've finally reopened the store!
The HAS is now available with a proper enclosure in three colorways. Printed at a 0.1mm layer height to minimize visible 3D printing lines (each case takes +3hrs to print
).
Stock is limited this time, so grab yours while it lasts - https://rgbslab.com/
Thank you!
The HAS is now available with a proper enclosure in three colorways. Printed at a 0.1mm layer height to minimize visible 3D printing lines (each case takes +3hrs to print
).Stock is limited this time, so grab yours while it lasts - https://rgbslab.com/
Thank you!
msamiullah
Professional
Beautiful enclosure!
invzim
Champion
Shiny!
Mafiaoso48
Beginner
Finally got one 
tom5151
Enthusiast
Blue and green enclosure already sold out 
.. but ordered one with a white enclosure
.. but ordered one with a white enclosure
Last edited:
I see you placed an order. I'll print the purple one instead of light grayBlue and green enclosure already sold out
Thanks!
Shin
Student
what about green and black like jp cps2 though? 
finally got those 3 jamma extender I needed.
gotta admit those psu kits and HAS cases are pretty slick, maybe another time
finally got those 3 jamma extender I needed.
gotta admit those psu kits and HAS cases are pretty slick, maybe another time
Snorlax0912
Beginner
Worth the Wait!After a long break, I've finally reopened the store!
The HAS is now available with a proper enclosure in three colorways. Printed at a 0.1mm layer height to minimize visible 3D printing lines (each case takes +3hrs to print
Stock is limited this time, so grab yours while it lasts - https://rgbslab.com/
Thank you!
Green/black would look slick. Too bad my 3D printer will be busy for a while now.. but I'll print this combinationwhat about green and black like jp cps2 though?
finally got those 3 jamma extender I needed.
gotta admit those psu kits and HAS cases are pretty slick, maybe another time
plasticfactory
Champion
Beautiful color combo. Glad things are back; thank you again for the AW multitap.
msamiullah
Professional
@RGB I have a question regarding ESD safety regarding these enclosures. I am assuming these are printed in PLA or Nylon which are insulators by nature, will this not cause an issue regarding ESD ? (I have limited knowledge of electronics so please forgive if I am missing anything obvious here)
This case is lovely. Feels so good in the hand protected like this. Sturdy like a NES cart. Would make transporting it a breeze!
Mazar~Tail
New User
Red? I didn't see Red. I WANT RED!This case is lovely. Feels so good in the hand protected like this. Sturdy like a NES cart. Would make transporting it a breeze!
The risk of static charge buildup is about the same as with the acrylic plexiglass case. Both can build a small charge if you rub them against something like fabric, which I wouldn’t recommend
You will be the most likely discharge point when you touch it, too.
msamiullah
Professional
Thanks, would there be any reason of CPS-2 I/O Interface not working on CPS3 Setup ?
BilonFullHDemon
Professional
Hi, I have an odd question, is the case designed to match hight of an PCB on standard arcade PCB feet?
Kreuz
Student
No, you will need some sort of support underneath the HAS if your PCB is on standard height feet.
BilonFullHDemon
Professional
Thank you!