Devil_mish
Student
Hey enthusiasts!
I've recently bought a blast city and I absolutely love it, and it works for the most part except a few small issues that I just can't figure out.
Monitor doesn't stretch fully to width edge:
I've tried adjusting the Nanao monitor via the remote but the pot is as high as it'll go, but there's still a good 2 cm either side of black.
Monitor width sometimes shrinks:
Maybe related to the above, very occasionally the screen will collapse very slightly for about 30 seconds before slowly enhancing again. This happens randomly but seems to be on start up, maybe as the machine is 'warming up'? (Added some photos, Tekken 4 with small black bars, marvel 2 when it's at it's worst)
Naomi 2 netdimm w/ capcom Io and 001 loom not powering:
Ah the classic, ill-fated combo. I have the 001 loom and it works perfectly with my namco system 2x6 with capcom Io. I've tried powering the Naomi without the capcom I/o but still nothing, and I've also adjusted the 5v and 3.3v pots and they are within 0.1v each. 12v is a bit low at around 11.3v though. Could this be the cause and therefore I'd have to pull the PSU out and see what's going on? I have powered this via my Vewlix PSU and plugged the rest into the blast and everything runs fine, or I have a separate sun PSU for power as an alternative.
Thanks in advance, any help is greatly appreciated!
I've recently bought a blast city and I absolutely love it, and it works for the most part except a few small issues that I just can't figure out.
Monitor doesn't stretch fully to width edge:
I've tried adjusting the Nanao monitor via the remote but the pot is as high as it'll go, but there's still a good 2 cm either side of black.
Monitor width sometimes shrinks:
Maybe related to the above, very occasionally the screen will collapse very slightly for about 30 seconds before slowly enhancing again. This happens randomly but seems to be on start up, maybe as the machine is 'warming up'? (Added some photos, Tekken 4 with small black bars, marvel 2 when it's at it's worst)
Naomi 2 netdimm w/ capcom Io and 001 loom not powering:
Ah the classic, ill-fated combo. I have the 001 loom and it works perfectly with my namco system 2x6 with capcom Io. I've tried powering the Naomi without the capcom I/o but still nothing, and I've also adjusted the 5v and 3.3v pots and they are within 0.1v each. 12v is a bit low at around 11.3v though. Could this be the cause and therefore I'd have to pull the PSU out and see what's going on? I have powered this via my Vewlix PSU and plugged the rest into the blast and everything runs fine, or I have a separate sun PSU for power as an alternative.
Thanks in advance, any help is greatly appreciated!