CVS2 Naomi linked freezes

No, keiichi is out of commission for a while. I have not experienced anymore freezing since using the IO he gave me. If it does freeze, I do have my link cable to try to capture the usb traffic. He solved his issue by just not using any JVS IO and converting it to jamma.
 
It is not so that might be way it hasn't frozen. But the original JVS I/O in my machine was freezing as well even when not daisy chained.
 
I’ve had this same problem at my commercial arcade and it resulted in me taking the game out of rotation for a while but im ready to try again.

I tested with different I/O boards and tried it with and without using the New Net City link board. Though in my case, I’m missing the power cable for the second link board so I’ve not had the chance to link things exactly as the manual recommends.
 
I put Type 3 Ringedge IO (837-14572) in another local CVS2 cab and there is no freezing in h2h JVS linked mode. Ran for 6+ hours without a single incident.

The setup was done using the splitter power cable in master cab with the black and white crossover power cable to the secondary. Secondary cab uses the power supply bypass cable so the IO is powered off the master cabinet.

Just wanted to share.
 
Last edited:
I put Type 3 Ringedge IO (837-14572) in another local CVS2 cab and there is no freezing in h2h JVS linked mode. Ran for 6+ hours without a single incident.

The setup was done using the splitter power cable in master cab with the black and white crossover power cable to the secondary. Secondary cab uses the power supply bypass cable so the IO is powered off the master cabinet.

Just wanted to share.
Can I just confirm I understand this setup.
The only difference is how the I/O is powered?
 
The Ringedge IO itself is a little wider than the stock IO in the NNC, but it mounts fine in the tray using only the 2 mounting holes on the right. The Ringedge IO needs pins 1 and 3 bridged (to enable digital controls).

With the proper PSU splitter cable and crossover cable from master cabinet to secondary, the secondary cab is powered from master cabinet's PSU. Only AC on the secondary cab is needed.
 
Back
Top