What's new

Home Arcade System

RGB said:
Hey, it really boils down to your TV/monitor compatibility and the OSSC settings (you could tinker with the H-PLL pre and post-coast settings, but I'm unable to tell you the right values). As for the switches on the HAS, please refer to the instruction manual - https://homearcadesystem.wordpress.com/instruction-manual/
Click to expand...
Thank you I didn’t know there was an instructions manual. Thanks for your help Mike, can’t wait to have fun with this thing. Very nice SuperGun by the way. Sturdy and clean looking 😄🙌🏼🤙🏼
 
  • Like
Reactions: RGB
THCsoftcore said:
Gradius III is also quite troublesome as it has off spec sync and creates issues with certain monitors when linendoubled.
Click to expand...
So can any of you guys explain to me why the new OSSC Pro that is due to come out in the near future and the new FPGA DE-10 NANO variants are supposedly going to fix all of these odd sync issues?
 
Just got my HAS, ahead of time even due to great post office RNG! Very easy to assemble with a good clear visual on what to do. I felt a little nervous with the long pins of the VGA adaptor, got got it in no problem. The SCART works perfectly with my OSSC and everything is in good order. Glad to have made this purchase and use it to conclude another supergun I got is not fully working, since this one fully is!
 
If I have the HD15 installed on the HAS, will the 8-pin port below it still work?
 
Thanks, is the HAS compatible with the Retrotink 5X?

My picture is rolling vertically.
 
Last edited:
tonyt76 said:
Not sure what I’m doing wrong then

@9999 Damage on the bottom are you using 75ohm or TTL?
Click to expand...
You have to adjust this potentiometer circled in pic. When I had that same scrambling issue that's what I did and it worked. 20221211_203625~2.jpg
 
erdrick1980 said:
You have to adjust this potentiometer circled in pic. When I had that same scrambling issue that's what I did and it worked. 20221211_203625~2.jpg
Click to expand...
Thanks J, I thought that was for gain? I’m using a meanwell cover that uses 24awg wires from the psu to the HAS. I’m suspicious of this.
 
tonyt76 said:
Thanks J, I thought that was for gain? I’m using a meanwell cover that uses 24awg wires from the psu to the HAS. I’m suspicious of this.
Click to expand...
I looked it up a while ago and can't remember where cause I was going nuts when my screen was acting up like yours and that's what it was. Moved left right until it straightened out.
 
erdrick1980 said:
I looked it up a while ago and can't remember where cause I was going nuts when my screen was acting up like yours and that's what it was. Moved left right until it straightened out.
Click to expand...
Thanks buddy I’ll give it a go
 
@erdrick1980 were you using your HAS with a PVM?

I have mine hooked up to a Retrotink 5X using a RGC scart cable. Turning that knob makes the picture darker/lighter.

TMNT works fine.
Aero Fighters rolls vertically.
Raiden DX no picture just sound.
Golden Axe has sprite issues.

These pcbs work fine in my jamma cabinet.
 
You must log in or register to reply here.
Back
Top