Home Arcade System
- Thread starter RGB
- Start date
Heatermania
Student
XtraSmiley
Legendary
Are you sure you have it plugged in right side up? I feel like that PCB looks the other way around. Check out 2:25 in this video:
View: https://www.youtube.com/watch?v=nbLJfZKDw08
If that's fine, try re-seating the PCB daughter board. I remember this game worked fine on my HAS BITD.
If that's fine, try re-seating the PCB daughter board. I remember this game worked fine on my HAS BITD.
Last edited:
Heatermania
Student
Anything I should know about the dialed in voltage? I found the switch for sync but now all I get is basically a blue pixel screen.
Heatermania
Student
It’s my HAS with a Retro Arcade US Power Supply
XtraSmiley
Legendary
Well, it's plugged in the right way, did you try all 3 settings for the sync? Also, give it 5.0v, it's a power hog for its size.
XtraSmiley
Legendary
If that’s the case I wonder if it’s been plugged in backwards before he got it. So many copies of this game are bad I wonder if that’s the cause, or there is something on it that regularly goes bad or bad soldier spots.I don't believe sync settings will change anything, it's likely something bad with the game
9999 Damage
Grand Master
Sorry if I missed it, but is there an ETA for the next batch of HAS? Totally understand that we’re in the holidays now, and I’m not in desperate need (I have four!). I just don’t want to miss it. 
Sorry if I missed it, but is there an ETA for the next batch of HAS? Totally understand that we’re in the holidays now, and I’m not in desperate need (I have four!). I just don’t want to miss it.
I'm bad at estimates, but I want to release it in January. It's a complete re-design, which still requires a bit more testing.
XtraSmiley
Legendary
I get new major versions of the HAS every time @RGB releases them, they are awesome!and i will see if i need to upgrade my 4.2 version
I don't normally get the incremental updates (4.0-4.2 for example), but major ones, they are MAJOR!
Gr0und_zer0
Student
I have a video output issue I've been trying to diagnose and I thought I'd ask here. The top lines of the image is shifted slightly to the left. My setup is H.A.S. V3 (2016) > OSSC (0.90 firmware) > Vewlix Diamand orange stock display. I have an 8pin miniDIN to SCART connecting to the OSSC. I tested with both a CPS2 board and MV1FZ and the issue remained the same. When the default OSSC test pattern is displayed, it looks perfect. I am including a pic of the CPS2 test pattern to show the issue. Apologies in advance if this is something stupid or obvious, I couldn't find anything in my searching of arcade projects or the internet at large.
Thanks,
Matt
Thanks,
Matt
Gr0und_zer0
Student
This is embarrassing but I can't figure out where I stored my old manual for it. I tried to compare to the current gen, but seem to recall V3 is jumper based for Cysnc setting.