What's new
By:

Ignignxkt's Vewlix Diamond Black Build!

Ignignxkt said:
As far as the custom io. This is how you hook it up. If you want home touchpad or other buttons you need his other harness which plugs into the top left port. He gave literally no instructions so don’t feel bad. Took some time for me to trial and error my way through it, too. I emailed him for some help, but his response didn't help me at all...

Basically, plug into the center port on the brook board and into the nearby port on the custom IO. Control board harness goes obviously on the left. I only have one player controls, but if you have two, you need another brook adapter and to do that all over again below. And then of course plug in the P1 harness on the bottom right. (if you have another player, plug in your other harness on the bottom left where it says P2)

IMG_6060.jpeg
Click to expand...
How is the latence by adding one more I/0 to the Brook ?
 
Kwanmister said:
Good looking vewlix!
Question: where did you buy the 4 button custom banapassport mount? I am looking for one to buy or 3d printed for my namco noir 2. Thanks
Click to expand...
I didn't print that one specifically but it's my design and I do offer to print them.

notsonic

Thread 'Banapassport Replacement Extra Buttons Panel for Namco Noir'

This replaces the entire Banapassport card reader and its bracket with a shell and panel for extra buttons. The panel fits pretty snug inside the shell, but you may want to glue it in place.

PXL_20230803_230503832.jpg PXL_20230803_230517871.jpg

I've got a few different panel options included. 4x24mm buttons, 2x24mm with square USB ports, and 2x24mm with round USB ports. I'm happy to take any suggestions for different panel layouts.

I printed it on a Prusa MK3S+ using PETG and the 0.3mm DRAFT settings.

Here's some of the design iterations I went through for anyone interested. First I started with a...
  • Like
  • Love
 
You must log in or register to reply here.
Back
Top