I took a break to clean the panels.
The laminate came off separate from the graphics. After the layer of plastic was off I had to razor the graphics off and copper scrub the steel to remove the rust.
Tomorrow they will go to the sandblast cabinet. I am trying to do anything that fits in the SB myself buts its about 3' wide and 2' deep.
Whats the best way to remove the extra adhesive before the sand blast?
The laminate came off separate from the graphics. After the layer of plastic was off I had to razor the graphics off and copper scrub the steel to remove the rust.
Tomorrow they will go to the sandblast cabinet. I am trying to do anything that fits in the SB myself buts its about 3' wide and 2' deep.
Whats the best way to remove the extra adhesive before the sand blast?