So after finding that the K91X1202A doesn't fit in my system (I assume that the mounting plates changed in later model Vewlix's) I managed to scrounge a K91X1204B. Pulled out the JVS board I'm not using (I have things wired to go to DB15 and then through a DB15 to JVS adapter. Easy to swap over to the IO board by switching the JST connectors) and installed the Fast IO board. However, I have a couple of things I wanted to double check before I plug it all in.
1. As with the JVS board, I assume I just need P1 for power?
2. The actual Fast I/O cable, is it just twisted pair RJ45 like Cat6?
3. I assume that the ribbon cable connector is the same, despite being rotated the other way around.
4. Any dip switch settings I should know about (or just what are the stock dip settings)?
Thanks,
1. As with the JVS board, I assume I just need P1 for power?
2. The actual Fast I/O cable, is it just twisted pair RJ45 like Cat6?
3. I assume that the ribbon cable connector is the same, despite being rotated the other way around.
4. Any dip switch settings I should know about (or just what are the stock dip settings)?
Thanks,