Thanks to you for using it!
I'm still without the printer, so I can say only thanks to print it.
I'll try to adjust it a little bit.
For the wing, on your photo, it's the one on the left?
And I'm curious... What about the hole for the screw?
It's alingned?
Thanks again!
Hi,
In case anybody need one, I've tried to replicate the Dimm battery cover so it can be 3D printed.
I'm still waiting for my printer so I can't assure it's 100% accurate. I've tried the best I could.
Yes, that's how it behaves right now.
I have my main computer connected to my network with Ethernet, and when I'm on tests with WiPi, I activate my computers wifi, and connect to the WiPi network, so I can use both.
And that way I can ssh the WiPi.
yes. that's it. you'll have to ssh WiPi and go to /sbin/piforce/lcd-piforcetools/piforcetools.py
I've found that the way piforcetools check for the LCD is completly dependent on the Raspberry revision:
I was trying WiPi with a PiZero for a minimal installation, and found that the LCD wasn't...
Hi @chunksin !
I've found what it's wrong with card emulator on WiPi.
You have to install pyserial, as it's missing.
Once done, everything works fine.
And I've found a typo in Fzero mode.
In cardemulator.php, this line names the mode F-Zero
echo '<a href="cardemulator.php?mode=fzero">F-Zero...
Please, check this post, as it's something like you describe.
https://www.arcade-projects.com/threads/naomi-netbooting-error-33-gateway-not-found-error.7080/page-2