I took a look, and I don’t know this processor at all unfortunately. So either someone else can take a look or I’ll get around to it again eventually because I would like to see it happen.Hm, I’ll take a look
I took a look, and I don’t know this processor at all unfortunately. So either someone else can take a look or I’ll get around to it again eventually because I would like to see it happen.Hm, I’ll take a look
You... DO know that that should be the official name, right? KI 1/2: Chief Thunder Multi or somethin like that lol
Got these yesterday. The turn around time was QUICK.
Ready to give some KI boards the Chief Thunder treatment.
(Get it? Because they look like tomahawks?)
yes. @BladeZX thoughts? It's your board after allYou... DO know that that should be the official name, right? KI 1/2: Chief Thunder Multi or somethin like that lol
I confirm. It’s difficult to introduce dual board on mobo. But i success with additional parts (look at the pictures)
as my picture...?@mthngn It'd be safer to remove the original switch, otherwise at some point you'll short A and B (when the sd card switch is in the A position and the PCB switch is on the B position for example). I'm not sure it's harmless for the selector.
thank you a lot.@mthngn in your picture, the wiring order is correct, but the switch on the dual sd pcb is still present. My advice would be to remove it.