GeorgeSpinner
Grand Master
When you desolder the PCB, test the switches with no remote location DIP PCB installed.I'm using the Jasen case dips. I was using the filter mount one just to make sure the behavior is consistent with the dips on the Jasen's case.
So, I did some more comprehensive testing using a few patterns of dips: all off, all on, alternating on-off, and alternating off-on. My findings:
So I'll redo soldering for A3, C4, and C6. Not sure what to make of the case where all dips are on.
- A3 behaves erratically
- C4 is always OFF
- C6 is always OFF
- If all dips are ON, the on-screen settings values (e.g. CONTINUE is ON) behave as expected as long as they don't rely on the bad dips above. But the dip readout shows all dips as OFF except for A3, which I mentioned behaves erratically.