Lswanson1049
Student
Any progress on this subject?
Can I just confirm I understand this setup.I put Type 3 Ringedge IO (837-14572) in another local CVS2 cab and there is no freezing in h2h JVS linked mode. Ran for 6+ hours without a single incident.
The setup was done using the splitter power cable in master cab with the black and white crossover power cable to the secondary. Secondary cab uses the power supply bypass cable so the IO is powered off the master cabinet.
Just wanted to share.
What do you mean by bridging pin 1 and 3 ? Which connector is that on ?The Ringedge IO itself is a little wider than the stock IO in the NNC, but it mounts fine in the tray using only the 2 mounting holes on the right. The Ringedge IO needs pins 1 and 3 bridged (to enable digital controls).
What do you mean by bridging pin 1 and 3 ? Which connector is that on ?