found
https://www.aliexpress.com/item/1005001571888475.html
not exactly cheap, but cheaper than the dual sd solution.
https://www.aliexpress.com/item/1005001571888475.html
not exactly cheap, but cheaper than the dual sd solution.
found
https://www.aliexpress.com/item/1005001571888475.html
not exactly cheap, but cheaper than the dual sd solution.
Anyone know where to get some good 32pin sockets that will mount on the add-on board and extend down long enough to plug into the sockets on the KI pcb
Yea crap - I will need to do thisI would be surprised if sockets like that are a thing (at least for anything that isn't machined pin). I think you will need to place separate pin headers on the PCB, like this
you mean the ki2 boot rom or the chd? I'm running the Ki2 conversion boot rom (killer_instinct_2_conversion_kit_u98_any_ide_boot_rom_d14p) which I patched. The disk image or CHD is a ki2 image.i wonder if your ki2 drive image is correct.
are you running the ki2 dedicated image or the one for the conversion kit?
Can you provide a valid chd link for ki2…I was using the one from thekillerinstinctproject page.the chd image i was refering to.
if the bootrom was bad i would expect it to just not run or give a checksum error.
Is there a special way to burn the roms (ie. setting within the eprom burner...I simply flashed them with a TL866 II pro)?
my body and KI1 board are ready.I have made the changes to the pcb
I will wait until prototypes get here to be sure they match the sockets on the pcb