OK
@Darksoft I've had my FULL kit for over a year in the box and I just finally got around to installing it. I know a lot has changed so here is what I wanted to clear up.
I just cut the battery off my MSHvsSF (93646B-7)
It has a BGSB3G PAL (but I ordered a GAL16V8B)
I have removed all the ROMs per the PDF
I installed both boards and connected via jumper board/IDE.
I have the 4 wire connector on CN9 but not soldered to the main DS board (firmware update?)
I connected the ribbon cable to the LCD.
1. Do I need to swap pal chips?
2. Do I need to put a jumper from pin 9 on Pal to J17?
3. Do I need to jumper out or remove any of those tiny jumpers on the B board?
4. I'm sure I need a firmware update since I see something about the Cn9 connector corrupting boot-loader if connected, and where do I get that firmware?
Thanks and super excited!!