UPDATED 4 JULY
Hi All
I would like some help please, i tried to read all the topic but it's hard to understand (I'm French) ,
I got a 93646b-6 , with a BGSB3F Chip PaL Chip , My board are Jap , original no suicided.
1) Do i need to suicide the board by removing the battery to use the cp2 multi ? (seems not since the new bios) I DID
2) My Chip is an F chip so , do i need to place a wire ?? from the pal chip to somewhere (instructions are not so clear for me) OK TO J17
3) I ordered with my Multi a PALG chip , do i need to place a different wire so ? (not certain of the chip , with all blanks chips issues) I'LL TRY LATER
4) To upgrade the board , just need to put the flash.img file on root ?
STILL BLANK SCREEN
Thanks !
--->
"
3. Solid screens on boot. The kit will say flashing the game and then playing the game but the screen is just a solid color. Sometimes white, sometimes red or orange, etc. This USUALLY has come down to incorrect writes of the rom the the SD card. But it also can come down to the old problem with encryption bits causing the decrypted code to not run, even if boards dead for years. In that case, shorting the EXC5 component "
Shorting EXC5 , permanently ? how ? then power on ?
I SHORTED EXC1 and EXC5 , unplugged , with a screw and plugged all again
--->> IT WORKS !
Thanks anyway