PARTY MAN X
Beginner
I will try today and report back, thanks for your suggestion@KingSopz try messing with the sync settings on the OSSC. I've had to change them for a couple of boards when run through the TSH. TGM2 needed the h.sync tolerance changed, Block Out needed PLL settings changed. Not sure what the CPS3's problem would be here.
You know why that is right?I've had to change them for a couple of boards when run through the TSH.
It would be great if you can back up your claims with source-code or documentation - better yet, get a TSH yourself and try it out before telling others what it can or cannot do. If you agree to write a page for my website with instructions on how to get the best OSSC results with the Jammafier + TSH, I'll send you one for freeLook I'm not shitting on TSH... but it WASN'T designed for this specific application (its for Trisync CRT monitors as the name implies).
The sync from the arcade PCB should be unprocessed and provided to the OSSC via SCART connector.
Basically the polar opposite of what the TSH is doing (ie regenerating/filtering the sync and feeding via DSUB/VGA).
The only change to the video coming from the arcade PCB into the OSSC should be attenuation to SCART levels (75ohm/TTL adjustable to support Taito F3).
Yeah, Trisync helper needs to be powered by the Jammafier. On earlier versions there's a solder jumper that needs to be bridged on the bottom. On newer versions there's a micro switch that needs to be flipped on the parts side that can be accessed by removing the plexi cover.Is the 5v jumper on the Jammafier bridged to power the trisync helper?
NNC+Jammafier+trisynchelper+15KHz games is pure goodness, perhaps like it even more than the image my other cab with MS9 has!
there are two connectors on the chassis one is set to accept rgb specs and the other is set for vga iirc. You have to connect to the vga one and combine with trisync helper to get the right valuesOk, hope you guys can help me nail down what the issue is that I have going on here.
Equipment:
NNC w/ PF D29CQ51
Jammafier
TriSync Helper
Various 15Khz boards
Every 31khz system I have shows a beautiful bright picture through the vga connector on the tube.
With 15Khz games:
When using a the Jammafier with the trisync helper, connected through the vga port it does not display an image, just black, not even the no signal error occurs.
When using a the Jammafier without the trisync helper connected, , connected through the vga port it does display an image, just extremely dull, cant adjust the brightest, I can max it out and it does nothing.
The only 15khz board I have tested so far to work that displays a beautiful bright picture using the jammafier, without the trisync helper, has been the CPS3, with the trisync helper, no image.
It is just bizarre, dont know what else to try. Anyone have this monitor, that is using a jammafier and have 15khz boards display correctly. Any suggestions?!