Ok bro, sending these your way to test fitment, etc.
I need another set of eyes on these.
DARKSOFT Multi JVS v1.0
- Thread starter Darksoft
- Start date
I need another set of eyes on these.
Ok bro, sending these your way to test fitment, etc.
I need another set of eyes on these.
BEAUTIFUL!
GravitySandwich
Student
Since today my MultiJVS has been starting to act up. It won't read any profiles from the SD Card and it does not get detected by the PC to flash. It however still works fine as a JVS I/O on the default setting. Anyone else had this issue?
@Derick2k The time is now! Plates arrived. Overall fitment is great, one minor suggestion with top connector not lining up with the clip cut out's. Cut out should be edge to edge. Bottom cutout is perfect btw.
I used the following standoff sizes:
Time for the rest of the wonderful photos!
I used the following standoff sizes:
- M4x20 +6mm
- M4x10 +6mm
- M4x5 +6mm
Time for the rest of the wonderful photos!
Nice, send me a pic with some measurements and Ill send you a revised top plate, I didnt have standoffs that fit, dont have any larger than M3 so had to go from rough measurements.
I see what you mean, Ill make the changes. How are the alignment of the holes for the buttons? I was gonna 3D print some buttons, or maybe make some from acrylic rods.
Ill send you another top plate on me. Thanks for testing it
Everything lines up perfect. Highly recommend M4 standoffs for those interested.
Just need to do this top cutout all the way to the edge of that notch with out the notch.
So this outline should work?
Yes this should work.
Ok done, will send it out tomorrow your way.
Awesome thanks!
I see what you mean, Ill make the changes. How are the alignment of the holes for the buttons? I was gonna 3D print some buttons, or maybe make some from acrylic rods.
Ill send you another top plate on me. Thanks for testing it
BTW hole alignment for buttons are spot on. Happy to test those also when those are ready money waiting
GravitySandwich
Student
I would be able to do that. I will first try with a few different SD's to play around. If not, i could replace the slot. What part number did you use for this exact slot?
GravitySandwich
Student
Managed to get the SD card situation fixed for now. Played around with some SD cards from varying sizes. 256, 512, 2GB, 4GB, 8GB and 16GB. All of them rarely worked apart from the 256mb that is now working fine. I will keep it in check if the 256MB starts acting up aswell. If so, i'll replace the slot.
arcadeWC
Professional
This looks great. I have a multi JVS; are there plans to make available for purchase or it is DIY only?
Thanks to @hyp36rmax for testing these.
If anyone wants to use these to make their own/tweak the design etc...here are the files in the compressed zip attachment.
If anyone wants to use these to make their own/tweak the design etc...here are the files in the compressed zip attachment.