What's new
I thought the speakers in these cabs were 8 ohm? 4 ohm are fine too?
 
Definitely considering getting an NVS4000 for one of my candies now... They're on eBay for $130 shipped right now which doesn't strike me as TOO insane. Losing -5v doesn't seem too killer considering I've picked up at least 1 volt meter edge that has a Negatron installed, and being able to power a full Naomi setup without anything additional is tempting...
 
I thought the speakers in these cabs were 8 ohm? 4 ohm are fine too?
I could have sworn they are 4ohm. I replaced mine with these and it’s a big improvement over the stock speakers. The NVS4000 is a very worthy upgrade if you decide to go that route.
 
If you really want to go overboard, you can get an NVS4000 and do a conversion; however you will lose -5v.
To use the NVS4000 in a NAC, what needs to the wiring exactly?
 
If you really want to go overboard, you can get an NVS4000 and do a conversion; however you will lose -5v.
To use the NVS4000 in a NAC, what needs to the wiring exactly?
Ideally you'll want a PSU complete with wiring already as the wiring seperately doesn't come up that often. I have found them seperately on YAJ back then.

rcyb_nvs-4000-harness.jpg
 
Last edited:
Sharp Image can refurb your psu if you are in the usa, however they seem to be getting overloaded lately. They did manage to fix up two canary psus for me recently. If you really want to go overboard, you can get an NVS4000 and do a conversion; however you will lose -5v. I would try to get your psu recapped/serviced before going another route.

These are direct drop ins for your NAC speakers and sound great in stereo:

https://www.ebay.com/itm/122684221284

Ninja edit: how bad is the harness? got a pic? - Those hirose edges are usually rock solid.
The -5v is easily fixed with a negatron, also I have only a hand full of boards which need it so not that important imo. The fact you have a stereo amp in there and you can power JVS devices from it are HUGE plusses imo.

Wow, you've found speakers which fit a NAC ánd sound better than the stock ones? I've bought 2 sets before, both didn't satisfy me so went back to OG speakers. Might give these a shot..
 
Sharp Image can refurb your psu if you are in the usa, however they seem to be getting overloaded lately. They did manage to fix up two canary psus for me recently. If you really want to go overboard, you can get an NVS4000 and do a conversion; however you will lose -5v. I would try to get your psu recapped/serviced before going another route.

These are direct drop ins for your NAC speakers and sound great in stereo:

https://www.ebay.com/itm/122684221284

Ninja edit: how bad is the harness? got a pic? - Those hirose edges are usually rock solid.
The -5v is easily fixed with a negatron, also I have only a hand full of boards which need it so not that important imo. The fact you have a stereo amp in there and you can power JVS devices from it are HUGE plusses imo.
Wow, you've found speakers which fit a NAC ánd sound better than the stock ones? I've bought 2 sets before, both didn't satisfy me so went back to OG speakers. Might give these a shot..
Yeah a few people recommended them to me, as mine were damaged. The best part is they are a direct drop in.

Depending how his wiring is setup, the nvs might be a direct drop in but it wasn’t for me. I had one of my friends help me out with it- it wasn’t too terrible, I just needed some connectors and repinning some stuff. Not sure what his username is here, it might be cpsystem3.
 
These are direct drop ins for your NAC speakers and sound great in stereo:

https://www.ebay.com/itm/122684221284
Will these fit for Astro City? I don't have any NACs but I'd love to replace the crappy speakers on my Astro City cabs with something that sounds way better and maybe can support stereo. Pretty sure the default sound setup is mono.
 
I had one of my friends help me out with it- it wasn’t too terrible, I just needed some connectors and repinning some stuff. Not sure what his username is here, it might be cpsystem3.
Is he called GeekMan1222 over on AO by any chance? :)
 
I had one of my friends help me out with it- it wasn’t too terrible, I just needed some connectors and repinning some stuff. Not sure what his username is here, it might be cpsystem3.
Is he called GeekMan1222 over on AO by any chance? :)
Nope, I was helping him with his install. He had an odd sound issue with his that I didn't have with mine. Bill D helped me with mine.
 
These are direct drop ins for your NAC speakers and sound great in stereo:

https://www.ebay.com/itm/122684221284
Will these fit for Astro City? I don't have any NACs but I'd love to replace the crappy speakers on my Astro City cabs with something that sounds way better and maybe can support stereo. Pretty sure the default sound setup is mono.
You can get some Cambridge soundworks speakers, and poach the speakers out of them to install. I had this done to mine when I had an OG Astro:

https://www.ebay.com/itm/Cambridge-...System-SBS51/202371224765?hash=item2f1e43d4bd
 
These are direct drop ins for your NAC speakers and sound great in stereo:

https://www.ebay.com/itm/122684221284
Will these fit for Astro City? I don't have any NACs but I'd love to replace the crappy speakers on my Astro City cabs with something that sounds way better and maybe can support stereo. Pretty sure the default sound setup is mono.
You can get some Cambridge soundworks speakers, and poach the speakers out of them to install. I had this done to mine when I had an OG Astro:
https://www.ebay.com/itm/Cambridge-...System-SBS51/202371224765?hash=item2f1e43d4bd
Thank you! I'll poke around some of my older speaker sets and see if I can't use those before I pull the trigger on the ones you linked. Much appreciated!

Sorry - didn't mean to derail the thread.
 
Haha no prob. Got my cap kit just need to get to it. Not sure what I’ll do about the jamma. I’m considering a little pass through voltage check board that I can get perfectly lined up with the old connector and secure it. Then I have a new edge and a voltmeter and can keep the harness.
 
These are direct drop ins for your NAC speakers and sound great in stereo:

https://www.ebay.com/itm/122684221284
Will these fit for Astro City? I don't have any NACs but I'd love to replace the crappy speakers on my Astro City cabs with something that sounds way better and maybe can support stereo. Pretty sure the default sound setup is mono.
finally got around to working on this. Recapped the power supply as people recommended. I used a jamma voltmeter adapter to get a new jamma edge. One of my friends is good with electricity and he did the recap and reworked my power situation. Got a step down transformer in the cab now. Dielectric grease fixed my noisy volume control. Put in these drop in replacement speakers I am quoting here, sound great. Thanks radiantsvgun! Next up paint the yellow speaker housing and install the marquee kit lions3 sells. Also installed an anycoin. So far so good. Here is a shot of my friend modifying some screws to replace the security ones holding the power plate on the back. Tested a Neo board and rastan, seems good! Thanks for all the suggestions!
 

Attachments

  • B921AB52-C676-4D8F-A640-01361589C70B.jpeg
    B921AB52-C676-4D8F-A640-01361589C70B.jpeg
    243.3 KB · Views: 295
Great, good job! Can you specify the difference regarding the speakers? How do the new ones compare to the stock ones? High and low both okay?
 
Great, good job! Can you specify the difference regarding the speakers? How do the new ones compare to the stock ones? High and low both okay?
I would say they sound fuller, better bass and treble. I am planning to wire them to a small car amp so I can hook up stereo boards and have bass and treble controls and maybe that extra level of control could bring the stock speakers to something similar.
 
Back
Top